Simpson Strong-Tie SET-XP56 Epoxy Anchoring Adhesive 56 oz. Tube

Key Features

• 1:1 two-component, high-solids, epoxy-based anchoring adhesive formula
• Passed the demanding ICC-ES AC308 adverse-condition tests pertaining to elevated temperatures and long-term sustained loads
• Code listed under the IBC/IRC for cracked and uncracked concrete per ICC-ES ESR-2508
• Code listed under the IBC/IRC for masonry per IAPMO UES ER-265
• Code-listed equivalent to cast-in-place reinforcing bars governed by ACI 318 and IBC Chapter 19
• Suitable for use under static and seismic loading conditions in cracked and uncracked concrete and masonry
• Cure times: 24 hours at 70°F (21°C), 72 hours at 50°F (10°C)
• Easy hole-cleaning — no power-brushing required
• Suitable for use in dry or water-saturated concrete
• For best results, store between 45°F (7°C) and 90°F (32°C)
• Available in 8.5 oz., 22 oz. and 56 oz. cartridges for application versatility
• Manufactured in the USA using global materials
• SET-XP is code listed for installation with the Speed Clean^™ DXS drill bits without any further cleaning (ICC-ES ESR-2508)
• Tested per ACI 355.4 and AC308

Applications

• Threaded rod anchoring and rebar doweling into concrete and masonry
• Recognized per AC308 to be used for rebar development and splice length design provisions of ACI 318
• Suitable for horizontal, vertical and overhead applications
• Multiple DOT listings

Storage

• For best results, store between 45°F–90°F. To store partially used cartridges, leave hardened nozzle in place. To re-use, attach new nozzle.

Shelf Life

• 24 months from date of manufacture in unopened side-by-side cartridge

Installation

• Surfaces to receive epoxy must be clean.
• Base material temperature must be 50°F (10°C) or above at the time of installation. For best results, material should be between 70°F (21°C) and 80°F (27°C) at time of application.
• To warm cold material, store cartridges in a warm, uniformly heated area or storage container. Do not immerse cartridges in water or use microwave to facilitate warming.
• Mixed material in nozzle can harden in 30 minutes at temperatures of 70°F (21°C) and above.
• Use only appropriate Simpson Strong-Tie mixing nozzle in accordance with Simpson Strong-Tie instructions. Modification or improper use of mixing nozzle may impair SET-XP adhesive performance.