Eye Bolts With Shoulder Includes Nut Partially Threaded Shank

Eye Bolts With Shoulder Includes Nut Partially Threaded Shank

Eye Bolts With Shoulder Includes Nut Partially Threaded Shank come in a variety sizes, materials, platings/coatings. Capacities listed are for vertical tension only (Parrel to Length of Bolt). See individual eye bolts for rating information.

Key Features

Other Shoulder Eyebolts

Eyebolt w/Shoulder No Thread Eyebolt w/Shoulder Fully Threaded

Applications

  • The receiving hole should be counter-sunk and be free and clear of any debris to assure proper seating.
  • LOADS SHOULD ALWAYS BE ALIGNED TO THE PLANE OF THE EYE, not at an angle to the plane. A steel washer or spacer may be used in conjunction with Shoulder Eyebolts to attain proper load alignment. The thickness of the steel washer or spacer must not exceed one thread pitch.
  • Check seating after applying an angular tension since the initial tension may cause the bolt to back away from the load. If such occurs, the Eyebolt should be unloaded & properly reseated.
  • For applications with untapped through-holes, longer length Shoulder Eyebolts are recommended, using a steel washer and nut for the required thread length of engagement.
  • Shoulder Eyebolt tapped holes are to have a threaded length which allows for full length of shank engagement and clearance for the unthreaded portion of shank.
  • Shoulder Eyebolts must be firmly seated and flush against the mating surface; otherwise, the rated capacity is reduced significantly. The use of a steel washer or spacer is permissible and may be required; however, the thickness must not exceed one thread pitch.
View as Grid List

Items 1-30 of 95

Page
per page
Set Descending Direction
View as Grid List

Items 1-30 of 95

Page
per page
Set Descending Direction